 |
|
Engine
- Engine Deere 6068T turbodiesel Rating 188 hp (140 kW) gross 166 hp (123.8
kW) continuous duty
- Fuel capacity 40 U.S. gallons (150 litres)
Rotary Drive
- Rotary system
- Pinion and gear drive
- Infinitely variable torque
- Rotary (high torque) 10,000 ft-lb (13,558 Nm) @ 0-50rpm
- Rotary (low torque) 4,500 ft-lb (6,101 Nm) @ 0-110 rpm Max.
- Rotary speed 110 rpm Mud flow rate Up to 250 U.S. gallons/minute (945 lit/min)
@ 1,500 psi (103 bar)
- Fluid course 2" (50 mm)
- Other features
- Rear mounted mud swivel
- 2" (50 mm) internal diameter
- drive brake
- floating carriage
- digital tachometer
- wireline commutator
- adjustable torque limiter.
Carriage Drive
- Max. thrust/pullback 60,000 lb (266.9 kN) low range
- Carriage system
- Rack and pinion
- Four pinion drive with adjustable force limiter
- Carriage speed (HI) 65 ft/min (19.2 m/min)
- Carriage speed (LO) 32 ft/min (9.8 m/min)
Pipe Loader (optional)
- Integral to drill
- Holds 9 pieces of 15' drill pipe
- Additonal pipe baskets each hold 9 pieces
- Total pipe on drill at one time is 270' (82.3m)
Drilling Unit
- Travel system -- self propelled on rubber tracks
- Drill angle 12 --26 degrees
- Wrench/clamp -- open top type
- Weight, drill unit
- Approx. 22,250 lb (10,100 kg) without pipe
- Approx. 26,250 lb (11,918 kg) with 18 pieces of pipe
- Hold down system
- H-beam stakes available
- Hydraulic augers available
Drilling Fluid Systems
- Triplex pump (optional) 0-130 GPM (0-510 lit/min) variable speed Max. pressure
1,500 psi (105.5 bar)
On Board Crane (optional)
- 6,000 lb (2,725 kg) rated capacity
- Remote control pendant
- Boom extends hydraulically
- Winch and slewing drive: high torque hydraulic motors
- Anti-two block device.
Drill Pipe
- Astec part number 01DT1516
- Length 15 ft. (4,570 mm) Outside dia. (tube) 3-1/2 inch (89 mm)
- Water course 1-3/4 inch (44 mm)
- Tool joint O.D. 4-1/8 inch (105 mm)
- Thread type 2-7/8 IF pin x box
Protective Equipment
- Each drill comes with dielectric boots and gloves, safety mats and electrical
grounding rods
- A Zap-Alert system is standard equipment
- Emergency shut down switch at driller's console
- The es!lok lockout system is standard equipment.
|
|
|
|
